Part Diagrams
-
Large bolt packs contain enough hardware for installing six handrail posts:- (12) 1" x 5/16" Carriage Bolts
- (6) 2" x 5/16" Carriage Bolts
- (18) 5/16" Washers
- (18) 5/16" Hex Nuts
-
Leg clamps come in two different sizes and are sold individually. The 1 1/2" leg clamp is part of the crossarm assembly and attaches two individual ramp sections. The 2" leg clamp mounts to the outside of a ramp or platform stringer and is used to attach legs. -
Legs are sold individually and include a 2" aluminum tube, footpad, and post cap. Rampit USA recommends purchasing legs longer than the needed application to allow for adjustments. We also recommend a diagonal brace for legs exceeding 48" in height. -
All Rampit USA aluminum ramps and platforms are assembled using a series of inter-connected pieces of light, and/or heavy tread. All tread pieces are six inches in length and can be cut to any width necessary. Light tread is standard on all residential platforms and portable ramps. -
All Rampit USA aluminum ramps and platforms are assembled using a series of inter-connected pieces of light, and/or heavy tread. All tread pieces are six inches in length and can be cut to any width necessary. Medium tread is used in all ramps and commercial platforms. There are two different types of medium tread in all Rampit USA ramp sections. The first piece of tread is open on the front and the back, and is known as starter tread. This enables ramp sections to be connected to one another. All remaining tread on a ramp section is standard medium tread, and is open on the front, but closed on the back. -
Plastic knuckles are inserted directly into the open end of two handrail components to create a corner that may not be exactly 90-degrees. -
Platform handrails are priced and sold individually and do not include ninety-degree corners or plastic knuckles for connecting multiple handrails. -
Post caps are sold individually and fit securely into the open ends of handrails or legs. Handrails utilize 1 1/2" post caps, while legs utilize 2" post caps. -
Ramp handrails are sold as a set and only include hardware for installation. Square ends, ANSI Loops, Knuckles, Corners, Caps, and inserts needed for terminating or changing handrail direction are all sold separately. -
Small bolt packs include all necessary hardware for attaching a set of handrails (four handrails posts) to a ramp or platform:- (8) 1" x 5/16" Carriage Bolt
- (4) 2" x 5/16" Carriage Bolt
- (12) 5/16" Washers
- (12) 5/16" Hex Nuts
-
Square ends are used to enclose and terminate the end of a handrail when space may be an issue. Square ends are sold individually and include pre-installed aluminum inserts (not pictured). Rampit USA recommends using ANSI loops whenever space allows. -
Stringers are shaped like an upside-down letter "F" and enclose all Rampit USA ramps and platforms. On platforms, two of the four stringers are usually flipped upside-down to create a smooth transition on and off the platform. Platform stringers are cut at 45-degree angles, whereas ramp stringers are cut at 90-degree angles. Stringers are sold individually and cut to the length specified. For a matching set, please add two of the same size to your cart.