Part Diagrams
-
90-degree corners are used to create right angles in handrails. All 90-degree corner pieces are sold individually and include an aluminum insert pre-installed on each end. To create handrail corners that are more or less than 90 degrees, please see plastic knuckles.
-
All Rampit USA ramps are attached to platforms using aluminum adapters attached to the ramp’s stringers. These adapters are reversible and can be used for ramps that go up or down. Each adapter pack includes two sets of adapters and hardware:
- (2) Aluminum Adapters
- (2) Angle Brackets
- (6) 1" x 5/16" Carriage Bolts
- (6) 5/16" Washers
- (6) 5/16" Hex Nuts
- (2) 1/4" x 1/2" Self-Tapping Screws
-
ANSI loops are the rounded ends of Rampit USA handrails. ANSI loops include pre-installed aluminum inserts (not pictured) and can be flipped to angle upwards or downwards.
-
The built-in adapter is an optional replacement for the uppermost piece of tread in a ramp section. The built-in adapter extends out beyond the end of the ramp, enabling the ramp to rest on the raised surface. Please select the length built-in adapter that best corresponds to the width of your ramp.
-
Crossarms are available in two different widths and include two crossarm clamps and two leg clamps. Crossarms do not include legs. For a complete assembly including legs, please see support assembly.
-
The crossarm clamp is part of a ramp's support assembly and is responsible for holding the crossarm in place on the leg. Crossarm clamps are sold individually and include all necessary hardware.
-
Handrail posts are the main components in all Rampit USA handrails and attach directly to the ramp or platform stringer using the hardware provided in a small bolt pack. Handrail posts are sold individually.