Part Diagrams
-
Leg clamps come in two different sizes and are sold individually. The 1 1/2" leg clamp is part of the crossarm assembly and attaches two individual ramp sections. The 2" leg clamp mounts to the outside of a ramp or platform stringer and is used to attach legs.
-
The crossarm clamp is part of a ramp's support assembly and is responsible for holding the crossarm in place on the leg. Crossarm clamps are sold individually and include all necessary hardware.
-
90-degree corners are used to create right angles in handrails. All 90-degree corner pieces are sold individually and include an aluminum insert pre-installed on each end. To create handrail corners that are more or less than 90 degrees, please see plastic knuckles.
-
Platform handrails are priced and sold individually and do not include ninety-degree corners or plastic knuckles for connecting multiple handrails.
-
All Rampit USA ramps are attached to platforms using aluminum adapters attached to the ramp’s stringers. These adapters are reversible and can be used for ramps that go up or down. Each adapter pack includes two sets of adapters and hardware:
- (2) Aluminum Adapters
- (2) Angle Brackets
- (6) 1" x 5/16" Carriage Bolts
- (6) 5/16" Washers
- (6) 5/16" Hex Nuts
- (2) 1/4" x 1/2" Self-Tapping Screws
-
Ramp handrails are sold as a set and only include hardware for installation. Square ends, ANSI Loops, Knuckles, Corners, Caps, and inserts needed for terminating or changing handrail direction are all sold separately.