-
Square ends are used to enclose and terminate the end of a handrail when space may be an issue. Square ends are sold individually and include pre-installed aluminum inserts (not pictured). Rampit USA recommends using ANSI loops whenever space allows.
-
90-degree corners are used to create right angles in handrails. All 90-degree corner pieces are sold individually and include an aluminum insert pre-installed on each end. To create handrail corners that are more or less than 90 degrees, please see plastic knuckles.
-
All Rampit USA ramps are attached to platforms using aluminum adapters attached to the ramp’s stringers. These adapters are reversible and can be used for ramps that go up or down. Each adapter pack includes two sets of adapters and hardware:
- (2) Aluminum Adapters
- (2) Angle Brackets
- (6) 1" x 5/16" Carriage Bolts
- (6) 5/16" Washers
- (6) 5/16" Hex Nuts
- (2) 1/4" x 1/2" Self-Tapping Screws
-
Leg clamps come in two different sizes and are sold individually. The 1 1/2" leg clamp is part of the crossarm assembly and attaches two individual ramp sections. The 2" leg clamp mounts to the outside of a ramp or platform stringer and is used to attach legs.
-
The crossarm clamp is part of a ramp's support assembly and is responsible for holding the crossarm in place on the leg. Crossarm clamps are sold individually and include all necessary hardware.
-
Stringers are shaped like an upside-down letter "F" and enclose all Rampit USA ramps and platforms. On platforms, two of the four stringers are usually flipped upside-down to create a smooth transition on and off the platform. Platform stringers are cut at 45-degree angles, whereas ramp stringers are cut at 90-degree angles. Stringers are sold individually and cut to the length specified. For a matching set, please add two of the same size to your cart.