Part Diagrams
-
90-degree corners are used to create right angles in handrails. All 90-degree corner pieces are sold individually and include an aluminum insert pre-installed on each end. To create handrail corners that are more or less than 90 degrees, please see plastic knuckles. -
Square ends are used to enclose and terminate the end of a handrail when space may be an issue. Square ends are sold individually and include pre-installed aluminum inserts (not pictured). Rampit USA recommends using ANSI loops whenever space allows. -
Handrail posts are the main components in all Rampit USA handrails and attach directly to the ramp or platform stringer using the hardware provided in a small bolt pack. Handrail posts are sold individually. -
Ramp handrails are sold as a set and specifically designed to fit Rampit USA Independence Series Ramps. Ramp handrails are actual size measured from end to end. Each handrail (2 per set) includes two handrail posts and two filler tubes for lengths 4' - 8' or three handrail posts and four filler tubes for lengths 9' and 10' only. Ramp Handrails include a small bolt pack for installation. Square ends, ANSI Loops, Knuckles, Corners, Caps, and inserts needed for terminating or changing handrail direction are all sold separately. -
All Rampit USA ramps are attached to platforms using aluminum adapters attached to the ramp’s stringers. These adapters are reversible and can be used for ramps that go up or down. Each adapter pack includes two sets of adapters and hardware:- (2) Aluminum Adapters
- (2) Angle Brackets
- (6) 1" x 5/16" Carriage Bolts
- (6) 5/16" Washers
- (6) 5/16" Hex Nuts
- (2) 1/4" x 1/2" Self-Tapping Screws
-
The self-adjusting bevel is installed at the start of every Rampit USA ramp and ensures a smooth transition on or off the ramp. -
Stringers are shaped like an upside-down letter "F" and enclose all Rampit USA ramps and platforms. On platforms, two of the four stringers are usually flipped upside-down to create a smooth transition on and off the platform. Platform stringers are cut at 45-degree angles, whereas ramp stringers are cut at 90-degree angles. Stringers are sold individually and cut to the length specified. For a matching set, please add two of the same size to your cart. -
Large bolt packs contain enough hardware for installing six handrail posts:- (12) 1" x 5/16" Carriage Bolts
- (6) 2" x 5/16" Carriage Bolts
- (18) 5/16" Washers
- (18) 5/16" Hex Nuts
-
Crossarms are available in two different widths and include two crossarm clamps and two leg clamps. Crossarms do not include legs. For a complete assembly including legs, please see support assembly. -
A support assembly is made up of a crossarm, including two leg clamps and two crossarm clamps, and two complete legs. Support assemblies are installed underneath a ramp and are used to connect two individual ramp sections.
-
Small bolt packs include all necessary hardware for attaching a set of handrails (four handrails posts) to a ramp or platform:- (8) 1" x 5/16" Carriage Bolt
- (4) 2" x 5/16" Carriage Bolt
- (12) 5/16" Washers
- (12) 5/16" Hex Nuts
-
The built-in adapter is an optional replacement for the uppermost piece of tread in a ramp section. The built-in adapter extends out beyond the end of the ramp, enabling the ramp to rest on the raised surface. Please select the length built-in adapter that best corresponds to the width of your ramp.